Descriptioin:
Low Stress Spiral Wound Gasket different from standard Spiral Wound Gasket, it's offeres the same high integrity seal associated with the SWG however.
The SUNWELL SW600-LS/LSI has been designed in such a way that compression and sealing requirements are achieved under very low seating stersses.
These gaskets are intended for use on Class 150 and 300 applications, where customers traditionally do not use the SWG due to concerns about exceeding allowable design stresses.
Winding Spefiction:
The gasket should be wound using a minimal pressure.
Recommended tightening torque for SW600-LS/LSI for flange according to ASME B16.20-2017, Kindly contact with SUNWELL Sales Team or Technical Team.
Fitting:
Gasket should be fitted as loose as possible, the gasket should no fail out and must rotate within the outer ring.